Editing Escalator2011 (section)

== Syntax Description ==
'''General'''
#number: each line of escalator code counts as one stairwell, so number as if each escalator is a stairwell
#numberofescalators: Specifies the number of escalators the unit(s) will have (currently only 1 and 2)
#direction: specifies direction in which the escalator faces (side where lower landing is), can be back, front, left, or right
#startfloor: specifies the lowest floor served
#endfloor: specifies the highest floor served, if you want to add an escalator spans multiple floors, place in the lowest floor + 1<br>'''Textures'''
#steptexture: this is the texture used on the escalator steps
#stepsidetexture: in most directions (except on left) this does nothing, but otherwise specifies the upright face of the steps
#landingtexture: this is the texture of the landings, which is the metal covering over the mechanical parts on the top and bottom of the escalator
#balustradetexture: this is the texture of the balustrades, should be a metal texture
#walltexture: this is the texture of the outer walls (external side of outer balustrades and underside)
#handrailtexture: this is the texture of the handrails<br>''' Position '''
#x: this is the central x (left-right) coordinate for the escalator bank
#z: this is the central z (front-back) coordinate for the escalator bank<br>'''Size'''
#width: this is the width of the escalators, default is 3.5
#height: this is the vertical height of the escalators
#steps: this is the number of steps the the escalators have, this is also the length of the escalators, this should be the height multiplied by 1.5 rounded to nearest whole number
#lengthbetweenescalators: in a double escalator setup, this is the width of the central balustrade, or the divider of the two escalators, the default is 2, the minimum is 1
#balustradewidth: this is the width of the outer balustrades (not the divider in AddDoubleEscalator), the default and minimum is 0.5<br>'''Cutting and Railings'''
#useautomaticcutting: Specifies whether to use automatic cutting (true) or not to use it (false).
#useautomaticrailings: Specifies whether to add automatic railings (true) or not to add them (false).
#extracutting: This determines the length of any desired extra cutting around the lateral sides of the escalators.
#railingthickness: Specifies the thickness of the railings.
#railingheight: Specifies the height of the railings (does not include interfloor height).
#railingtexture: Specifies the texture of the railings.