Talk:Skyscrapersim Building Creator Reloaded

Invalid Ending Floor

Note that this applies to all versions of SBCR (including Skyscraper Building Creator Supreme and SBCS V3). I have run into an issue where it says Invalid Ending Floor if I set some stairs and / or elevators to go up to the roof level of the created building but did not build anything there. I tested in the original, Supreme, and Supreme V3 and the result is the same, though I haven't tried it when adding a small floor onto the roof floor area. Elevator1512 (talk) 10:53, 1 May 2024 (CDT)

Note to @Lighthouse Friesland: I haven't tried this in LFBC, but let me know if you encounter the same issues following the steps above. Elevator1512 (talk) 10:56, 1 May 2024 (CDT)

Ok Lighthouse Friesland (talk) 11:01, 1 May 2024 (CDT)

I encountered the same issue once when wanting to create a roof terrace in Park Inn Tower Berlin.

It's because the floors are not listed. Lighthouse Friesland (talk) 11:03, 1 May 2024 (CDT)

I even looked at the code and checked to make sure I set the High floor to be 12 (as I was going for a ground floor and 10 regular levels plus a mechanical floor 11) Elevator1512 (talk) 11:06, 1 May 2024 (CDT)

The Beno Building Creator had not that issue. Lighthouse Friesland (talk) 10:59, 1 May 2024 (CDT)

This is why I'm using BBC to create the Line Tower, even though there won't be any stairwells because of that. Elevator1512 (talk) 11:07, 1 May 2024 (CDT)

Well, probably you could try to hand-code a stairwell. Right? Joao84704 (talk) 16:36, 1 May 2024 (CDT)